Over the years i made a lot of diy guitar amps but this is the first time i use the LM386. I made transistors and IC based guitar amps but never a DIY LM386 guitar amp, so i ordered some LM386 … Continue reading
I had this idea about making a homemade bar clamp for a long time, the idea involved from making a homemade C clamp intro a homemade bar clamp from rebar, as i didn’t know if it would work i took it as … Continue reading
For all of my voice overs i’ve been using an USB microphone, but my laptop already has a stereo mic input so i thought maybe i should free one USB port and use that input, and i couldn’t just go and buy a … Continue reading
Just for fun i wanted to try and make a spybug or an FM transmitter, after some googeling i found a lot of designs but they all have the same working principle which is frequency modulation: modulate a higher frequency with smaller one, in … Continue reading
I run out of solder wick one night while i was repairing a power supply, i needed to clean some PCB traces so i improvised a solder wick, it’s not the that efficient or easy to use but it works and i got the … Continue reading
There is times when i want to cut something that is hard to reach, and a regular hacksaw wouldn’t work, so all i do is wrap a cloth around a hacksaw blade and hold it with some tape and cut with it, … Continue reading
A solder fume extractor is some thing i always wanna make, i do a lot of soldering and desoldering jobs and that smoke released by the solder and the flux is so nasty specially on the older or vintage electronics. … Continue reading
After the last attempt to make the nut bracket, i can say now that the idea is working, all i need to do now is shorten the nut and remake the bracket with a stronger corner steel. As you can see from … Continue reading
I got this belt sander for a long time ago i bought it used for cheap, i don’t use it that much but last time i turned it on i couldn’t stand the noise and the vibration so, i decided to replace … Continue reading
Handle side mechanism. After i got all the components needed let’s get busy!. Basically i need to do 3 things ,make some kind of a washer for the bench vise screw to push against when tighten the vise, and a bushing to compensate … Continue reading